Results 1 to 4 of 4

Thread: polycom installation

  1. #1

    Default


    I am trying to install polycom phones using Auto-Configuration. the phone accept the configuration but after the boot I can't make any call and I am reciving the calls. the display show "Link is down" . any recommendation.

    Regards,


  2. #2

    Default

    alraiky,

    Is this a polycom 301, 501 or 601? What version of the firmware are you using on the Quadro? Have you reviewed any of our documentation on how to install an IP phone on the LAN side?

  3. #3

    Default

    it's 301. and I am using the latest firmware 4.0.4. and I am following the document http://www.epygi.com/pdf/TS/PolycomS...P300For3.0.x-M edRes.pdf

    but still I can't make calls from the device.


  4. #4

    Default



    Link is down is shown on screen if something wrong with your ethernet network connecton. Please check if you network cable (and if that cable is connected to the LAN port of the phone). Phone should not show that message. Then try to bring the Polycom phone to firmware default state and then reboot it.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Polycom SoundStation 4000 IP
    By jpisteve in forum Hardware Interoperability
    Replies: 5
    Last Post: 06-24-2009, 09:38 AM
  2. Polycom Sound Point 650 Phone
    By mshollack in forum Hardware Interoperability
    Replies: 2
    Last Post: 02-12-2008, 05:11 AM
  3. Compatibility with Polycom 601
    By testepygi in forum Hardware Interoperability
    Replies: 1
    Last Post: 10-16-2006, 03:11 PM
  4. Polycom Soundstation IP 4000 Configuratio
    By jpisteve in forum 'How Do I' Questions
    Replies: 1
    Last Post: 09-06-2006, 07:51 PM
  5. Problems with Polycom 301
    By jchavez in forum Installation
    Replies: 4
    Last Post: 08-17-2006, 06:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •