Results 1 to 2 of 2

Thread: E1 busy tone error

  1. #1

    Default


    Hi,

    Some times when we try dialing though our E1 gw, we get "
    a busy tone". When we try calling in the same happens. From the failed
    call statitics, we get the reason below for failure

    "Temporary Unavailable"
    ISDN : No circuit/channel available



    At the time of the error all channels are free. i can tell this from "line status page"

    We are having to reboot the E1 gw to clear this issue





    Edited by: afripayments

  2. #2

    Default


    Hello,



    Did you purchase this unit from Epygi? If so I would recommend that
    you open a Technical Support Request on this issue so that we can
    gather all necessary information about your connection and also about
    the issue.



    Thank you

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. outbound calling error
    By mheller in forum Troubleshooting and Problems
    Replies: 3
    Last Post: 11-29-2007, 04:04 PM
  2. FXS port on unending Call state: Busy
    By todash in forum Troubleshooting and Problems
    Replies: 4
    Last Post: 08-19-2007, 03:49 PM
  3. busy signal
    By ttsrocky in forum Troubleshooting and Problems
    Replies: 1
    Last Post: 01-23-2007, 07:05 PM
  4. Error trying to update Quadro16Xi
    By anestis in forum Troubleshooting and Problems
    Replies: 1
    Last Post: 09-08-2006, 06:36 PM
  5. VM Settings page causes unstable error.
    By threebit in forum Troubleshooting and Problems
    Replies: 1
    Last Post: 09-07-2006, 11:42 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •