Results 1 to 1 of 1

Thread: Quadro fxs 16 port Installation

  1. #1

    Default Quadro fxs 16 port Installation

    Hello everyone,,
    I have a quadro fxs 16 port gateway and a quadro pbx m8l.
    I need to replace a grandstream fxs gateway 4008 and a sipura gateway.
    The PBX is at one location and the grandstream and sipura gateway are at another location.
    How can I setup the 16 port gateway to so work with my m8l.
    I have a vpn connection between the two locations.

    In my pbx I have all extension programmed and the phones connected to the fxs gateway are analogue.
    The wan port of fxs 16 Appvalley https://inro.in/cyberghost/ https://inro.in/expressvpn/ gateway, is in the same ip range of the pbx and I pinged the pbx on the fxs 16 and it pinged.
    I also have the fxs 16 on PnP and also tried tried stand alone mode, no success.
    If I try to make an extension on the fxs 16, I see that sip option is shown.

    The firmware version of the fxs 16 is 5.2.7 if I am not mistaken.
    Last edited by Sarfarosh; 02-03-2019 at 12:03 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Question about Quadro FXS 16 port
    By zet in forum 'How Do I' Questions
    Replies: 2
    Last Post: 05-15-2013, 01:20 PM
  2. Installing quadro fxs 16 port
    By zet in forum 'How Do I' Questions
    Replies: 0
    Last Post: 05-02-2013, 04:48 PM
  3. connecting a analog door phone to FXS port of a quadro 2X
    By wbts in forum 'How Do I' Questions
    Replies: 1
    Last Post: 06-11-2010, 08:18 AM
  4. FXS 16 port gateway
    By ptc in forum 'How Do I' Questions
    Replies: 3
    Last Post: 06-07-2010, 08:56 AM
  5. FXS port on unending Call state: Busy
    By todash in forum Troubleshooting and Problems
    Replies: 4
    Last Post: 08-19-2007, 04:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •