Results 1 to 2 of 2

Thread: Using FXO line with Fanvil X4G

  1. #1

    Default Using FXO line with Fanvil X4G

    Good day,

    How do I configure a Fanvil X4G phone to use FX0 ports 1 or 2 on a QX50 with firmware 6.1.6?

  2. #2

    Default

    Quote Originally Posted by ryireland1 View Post
    Good day,

    How do I configure a Fanvil X4G phone to use FX0 ports 1 or 2 on a QX50 with firmware 6.1.6?
    Probably easier ways, but you could build each FXO into a different route and give each a route code. Example, to use FXO1 dial 7 + 10 digits, to use FXO2 dial 8 + 10 digits.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to have an extension pickup the fxo line when going offhook
    By irnchriz in forum 'How Do I' Questions
    Replies: 1
    Last Post: 07-29-2011, 02:37 AM
  2. FXO Line problems on M26x
    By nicolab@gracan.co.za in forum Troubleshooting and Problems
    Replies: 5
    Last Post: 06-07-2011, 10:46 PM
  3. QUADRO6L + SPA942's - Bind line buttons to FXO?
    By quadroconfusion in forum 'How Do I' Questions
    Replies: 1
    Last Post: 02-11-2011, 01:11 AM
  4. Replies: 7
    Last Post: 05-21-2009, 01:25 PM
  5. FXO line configured for Both
    By etolentino in forum 'How Do I' Questions
    Replies: 0
    Last Post: 11-21-2006, 12:31 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •