I have successfully set up a VPN tunnel for our remote home user - for everything except her IP phone (Snom 360).

We used to have a 2xi on, and I upgraded to a 16xi on running 5.39. During the upgrade they were both 'live' so that I could compare the settings. Her phone used to be fine on the 2xi.

The 2xi is now out of service and disconnected.

Problem is, when I run Traceroute on, the first hop is to! And fails of course, there being nothing on 200.

I can't seem to find any setting in the 16xi of '' - did the 16xi learn this route when it was set up?

A most importantly, how can I change it to our actual router address of