Results 1 to 4 of 4

Thread: Quadro 4x v5.1.39 does not have option to configure via wan port

  1. #1

    Default Quadro 4x v5.1.39 does not have option to configure via wan port

    Hi all

    I need to be able to configure my lines via the wan port. On the unit the drop down for this option is not in the telephony / lines page where it should be.

    Is there some global switch I need to get this active. It is an old system that has been upgraded over the years from version 4.x, but the option to configure phones via the WAN port should work as of version 5.1 from what I have read.

    Regards

    Mark

  2. #2

    Default

    Gday Mark, deployment on wan port appears to be on the later systems unfortunately not available on 5.1.39 as far as I am aware.

    Kev

  3. #3

    Default

    Quote Originally Posted by KSComs View Post
    Gday Mark, deployment on wan port appears to be on the later systems unfortunately not available on 5.1.39 as far as I am aware.

    Kev
    Yes thanks Kev. You are right. I went through release notes and found it is in 5.2.x

    The manual I found said it was in 5.1.38 and greater, but this was obviously wrong.

    I sorted it the old hack way by putting an alias on the router in a different subnet and plugging both interfaces into the switch and setting the wan interface to use the alias as its gateway.

    Cheers

    Mark

  4. #4

    Default

    Mark, just be aware that the maximum concurrent calls a remote / wan side extension can have is 2 - TWO ( 1 + 1 ) only .. where as the Lan side is far greater - to 8.

    Just a FYI.

    Kev

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Quadro 2x2 WAN port speed
    By A41IT in forum General Discussions
    Replies: 2
    Last Post: 08-09-2014, 12:55 AM
  2. Configure IP phones from WAN
    By mbagshaw in forum 'How Do I' Questions
    Replies: 1
    Last Post: 03-12-2013, 01:55 AM
  3. Time Service NTP on Quadro WAN Port
    By WardG in forum 'How Do I' Questions
    Replies: 2
    Last Post: 01-10-2012, 06:24 PM
  4. Configure Quadro M8L and Phones to have Phones on WAN
    By flyboy_dea in forum 'How Do I' Questions
    Replies: 4
    Last Post: 06-08-2011, 09:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •