Results 1 to 2 of 2

Thread: DID line to Snom 710/821

  1. #1

    Default DID line to Snom 710/821

    What is the proper way to route DID calls to each extension/phone?

    I tried to find the answer in the Manual and didn't have any luck.

    Thanks!

  2. #2

    Default

    Option 1. Assign the DID number to your extension as a SIP User Name (on SIP Registration Settings page of extension)
    Option 2. Create a virtual extension (without any line connected to it) and assign the DID number to that virtual extension as a SIP User Name. After that on virtual extension configure unconditional call forwarding to your extension.
    Option 3. Create new call routing rule in Call Routing Table with the following parameters:
    Destination Number Pattern: (enter DID number)
    Number of Discarded Symbols:99 (to remove all digits of the DID number)
    Prefix: (enter your extension number)
    Destination Type:PBX
    This rule will rout the calls to DID number to your extension.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Snom 710 support?
    By RiverRat812 in forum Hardware Interoperability
    Replies: 4
    Last Post: 03-18-2013, 03:57 AM
  2. Snom 821 call hunting
    By BWesley in forum 'How Do I' Questions
    Replies: 3
    Last Post: 05-16-2012, 12:53 PM
  3. Snom 821 no attende call transfer
    By fmeza in forum Hardware Interoperability
    Replies: 1
    Last Post: 04-27-2012, 07:35 PM
  4. SNOM 821 Firmware Virsion with Quadro6L
    By WardG in forum Installation
    Replies: 2
    Last Post: 02-17-2012, 11:56 PM
  5. Reception SNOM 821
    By peterd in forum Installation
    Replies: 1
    Last Post: 07-15-2010, 09:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •