Results 1 to 2 of 2

Thread: Redialing from "call history list"

  1. #1

    Default Redialing from "call history list"

    Epygi Quadro 2X2 SW 5.3.14
    Cannot redial calls from "Call History" list....Recording says "number dialed does not exist"

  2. #2


    Sounds a lot like my issue.

    An inbound call will be stored in the phone history as 'number@<ip of QuadroISDN>'. When redialing out it attempts to send it directly via that device which is rejected.

    I've not found a solution yet.

    And its solved. I had to add a Call Route that redirected the call properly back through the MX32. Its a bit of a hack but it works
    Last edited by bundabrg; 02-04-2014 at 10:29 PM.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Error {"msg": "Authentication with 3pCC failed!"}
    By in forum Troubleshooting and Problems
    Replies: 2
    Last Post: 08-31-2011, 05:17 AM
  2. Call Queue "491" SIP response
    By ranko in forum General Discussions
    Replies: 0
    Last Post: 08-23-2011, 08:01 AM
  3. "Authorization" error message for unsucessful call
    By tsim in forum Troubleshooting and Problems
    Replies: 10
    Last Post: 10-27-2010, 01:29 AM
  4. Diferences between new features "Listen-in", "Whisper", "Barge-in"
    By MefhigosetH in forum Suggestions and Feedback
    Replies: 1
    Last Post: 10-22-2009, 04:09 PM
  5. Call routing: SIP versus IP-PSTN "Call type"?
    By mobidutch in forum 'How Do I' Questions
    Replies: 1
    Last Post: 03-13-2008, 04:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts