QuadroFXO Gateway as Expansion Board

[ftoledano]

Hi everybody, i already followed the instructions to share my quadro fxo gateway (6 fxo lines) with my quadro m8l but it doesn't works...no yet

My M8L (10.2.1.200) has DHCP for LAN , i connected the FXOGateway WAN's (10.2.1.147) to the M8L LAN's Port, and the FXOGateway LAN Port to my PC.

I enabled the PSTN external lines, i set an user and password test/test in the Quadro M8L

Now i moved to the 10.2.1.147 to activate the PSTN Lines shared. I enabled the setting with the properly parameters test/test master device ip: 10.2.1.200 and port: 5060 and saved that.

I checked the FXO lines settings in my FXO gateway and they are now routing to my M8L AA

When i check the FXO lines settings in the M8L there are just 8 FXO lines assigned,...not 14

What am i doing bad or what did i messed up ?

Please someone answer !

[Ashot]

Your M8L has DHCP enabled for LAN, you connected the FXO GW WAN to the M8L LAN so assuming FXO GW should receive IP address from M8L. The DHCP IP address range for M8L is 172.30.0.100-172.30.0.254. So how FXO GW received 10.2.1.147 as IP?

[ftoledano]

Your M8L has DHCP enabled for LAN, you connected the FXO GW WAN to the M8L LAN so assuming FXO GW should receive IP address from M8L. The DHCP IP address range for M8L is 172.30.0.100-172.30.0.254. So how FXO GW received 10.2.1.147 as IP?

Thanks for the update, because we assigned the IP address 10.2.1.200 and the range for DHCP LAN is 10.2.1.101-150/24

By the way, the FXO gateway has already the 10.2.1.201 and already has shared his FXO lines to the M8L but i can't configure them. Let me show you.

[Ashot]

Your FXO GW isn't registered on M8L. By the way M8L with IP address 10.2.1.200 couldn't have the range for DHCP LAN as 10.2.1.101-150/24. M8L should refuse such configuration with error message.
To be honest is there a strong reason you don't want the FXO GW to receive IP from DHCP IP address range of 172.30.0.100-172.30.0.254?