Results 1 to 8 of 8

Thread: New firmware 5.3.11 & 5.3.13

  1. #1

    Default New firmware 5.3.11 & 5.3.13

    i found following differences
    1/
    on Q2x and Q4x the DCC features are not listed on features.cgi page
    ( they are on a M32x )
    How to use featurestrial ?
    Would a valid DCC key accepted ?

    2/
    on M32x the edit watch adresse list is not available
    ( it is on a Q2x and a Q4x )
    would it become available when uploading a valid DCC key ?

  2. #2

    Default

    Hi,

    1. On Q2x FW 5.3.11 and Q4x FW 5.3.10 the DCC option isn't visible in the features list by default. But upon activating DCC feature by a license key (permanently or by trial) it becomes visible. This is just because a SW bug and should be fixed for the next releases.

    2. On M32x FW 5.3.13 the Edit watch address list is missing, will be restored back in the next release

    Thanks
    Ashot

  3. #3

    Default

    thanks for info

    i suppose that watch adresses is PBX-* by default
    henri

  4. #4

  5. #5

    Default

    I have problem with the Autoattendant that sometimes does not detect the incoming call and do not reply it. Could you please advice?

    best regards,

  6. #6

    Default

    The posted atuoatendant problem is for Quadro26x

  7. #7

    Default

    Hello i need firmware for my Quadro2X from Firmware Version: 5.0.16/Release and above.

    Please it's urgent

  8. #8

    Default

    look it up in Epygi Support Center » Downloads » Archive » IP PBX Products » Quadro2x, 2xi » Software

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. New firmware version 5.3.11 is available?
    By pjetson in forum Announcements
    Replies: 1
    Last Post: 08-20-2012, 06:27 AM
  2. Remote 4x firmware upgrade, can it be done?
    By sring in forum Troubleshooting and Problems
    Replies: 3
    Last Post: 02-22-2011, 07:54 PM
  3. Remote 4x firmware upgrade, can it be done?
    By sring in forum 'How Do I' Questions
    Replies: 0
    Last Post: 02-20-2011, 12:52 PM
  4. Remote firmware upgrade/install
    By sring in forum Installation
    Replies: 0
    Last Post: 02-20-2011, 12:51 PM
  5. snom firmware update on 4.1.18
    By dmaunder in forum Installation
    Replies: 1
    Last Post: 04-12-2007, 03:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •