Results 1 to 2 of 2

Thread: Video Call epigy E1

  1. #1

    Default Video Call epigy E1

    Hi,

    We have in office panasonic TDA200 with PRI card for E1 link and have tundberg 550 mpx video call conferencing with 3 x ISDN/BRI connection. Person who configure panasonic make three extension on panasonic as BRI and it is connected to video conferencing device. Everyting works fine. When video device initiate call establish audio over one channel 64 kbps after that it is takin 2 or 3 channel and establish video over it. We implement epigy E1 with two E1 trunk like bridging between panasonic and telecom so we can managing all call through call routing table on E1 gateway. We done that because we do routing some call inside vpn using sip. On this way voice call working, fax is working. Problem is with video conference. Video device initiate and establish audio and after that when try to establish video it's fail. My question is someone had similar problem or have some leads what to check?

    Best Regards

  2. #2

    Default

    I have experienced a similar problem for a while, but for an unknown reason it just stopped. I am not sure what exactly we did change, but now it works.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How do I connect to the epigy from outside?
    By k2srl in forum 'How Do I' Questions
    Replies: 6
    Last Post: 06-24-2010, 10:02 AM
  2. Video Call and QUADRO
    By Janousek2 in forum Troubleshooting and Problems
    Replies: 9
    Last Post: 03-04-2010, 06:47 AM
  3. Epigy 4x
    By smill61 in forum Français
    Replies: 0
    Last Post: 09-08-2009, 02:37 AM
  4. Degroupage Coriolis et Epigy
    By smill61 in forum Français
    Replies: 2
    Last Post: 09-08-2009, 02:32 AM
  5. sav epigy ?
    By LSI in forum Français
    Replies: 1
    Last Post: 11-26-2008, 12:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •