Results 1 to 2 of 2

Thread: Interconection betwen gateway and IPPbx

  1. #1

    Default

    How can I conect a gateway and IPPBX to take a digital services installed in this side, if the gateway is out of my office, both devices are conected to the internet with Dynamic IP address at diferent places?

  2. #2

    Default



    You may use the Quadro Call Routing table to route any call with some prefix to any destination. And that destination may be your gateway. And for the calls from the gateway to the Quadro you may configure the gateway dialplan to route the desired calls to the Quadro.


    Alternatively, if your gateway used to register with a SIP server, thenyou may register it with the Quadro as an IP Line. This will allow the gateway to be registered with the Quadro, hence the Quadro will be aware of any change of the gateway IP address.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. change default gateway
    By TFIDemo in forum 'How Do I' Questions
    Replies: 5
    Last Post: 11-05-2007, 04:24 AM
  2. IPSec LAN routing when not gateway
    By tritek in forum 'How Do I' Questions
    Replies: 2
    Last Post: 10-04-2007, 11:59 AM
  3. Ericsson F220m GSM Gateway
    By markadek in forum Hardware Interoperability
    Replies: 1
    Last Post: 09-09-2007, 05:00 PM
  4. NAT With Symantec Gateway Security
    By baoan in forum Troubleshooting and Problems
    Replies: 0
    Last Post: 05-01-2007, 12:20 AM
  5. VOIP/GSM Gateway
    By HL2DFR in forum Hardware Interoperability
    Replies: 2
    Last Post: 10-02-2006, 11:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •