Results 1 to 2 of 2

Thread: Redirect based on sip address

  1. #1

    Default Redirect based on sip address

    Hello, please can anyone give me a step by step on this concept
    I want to redirect all incoming calls from a specific sip address (ie. 11111111@sip.eypgi.com) to an auto attandant via the call routing table. Tryed loads of different ways, I am stuck.

  2. #2
    Quadro Architect
    Join Date
    Jun 2006
    Location
    Around myself
    Posts
    2,075

    Default

    Do I understand right, that you want to redirect ALL calls from that address, regardless of the called number?? The call routing table is based on the destination number, not the source, so this is not easy to achieve.

    I suppose this is a gateway device, not aPBX?
    You can try the following:
    set the "Route all incoming SIP calls to Call Routing" checkbox ON.
    Then on ALL the routing rules, set the Inbound filter to {?,??,???,????,?????,??????,???????,????????,!1111 1111}.
    You have to do that as the system doesn't allow to use {*,!11111111} syntax... If your callers can have usernames longer than 8 digits, then you will need to add ?????????,??????????,,.. etc to that list (the max number of questionmarks is equal to max number of digits in possible callers' usarnames...
    At the end if the table have a single routing rule with
    pattern=*,NDS=99,prefix=00,calltype=PBX,...

    So all the callers will be passed thotugh existing routing rules, and if nothing matches, will be routed to 00. The 1111111@sip.epygi.com will be routed to 00 immediately, as no rule will match for him.

    This is not very elegant way, but as soon as you don't provide any specific info on your specific config, this is the only way I can think of (the most generic). With nore information on usage of this device (possible callers/destination etc), I might suggest something else...

    Best regards,
    David

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Redirect VIA PSTN on E1.
    By rulrich in forum 'How Do I' Questions
    Replies: 8
    Last Post: 04-30-2009, 02:05 PM
  2. Redirect calls at night
    By andy in forum 'How Do I' Questions
    Replies: 1
    Last Post: 12-11-2008, 03:35 PM
  3. AJAX Based UI
    By greenbox in forum Suggestions and Feedback
    Replies: 0
    Last Post: 07-25-2007, 04:46 PM
  4. lan based QOS
    By matkinson in forum 'How Do I' Questions
    Replies: 6
    Last Post: 02-13-2007, 10:31 PM
  5. Time based branching.
    By threebit in forum VXML Scripting on Quadro
    Replies: 2
    Last Post: 06-21-2006, 01:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •