Page 3 of 3 FirstFirst 123
Results 21 to 24 of 24

Thread: Can't Receive Incoming Call

  1. #21

    Default

    It is port 5060 all the way through to the epygi unit.
    I have checked and is 5060 as they ports for SIP on the unit.

  2. #22

    Default

    When I telnet to the device, it gives a black screen, but unless the quadro responds to these requests I wouldn't expect to see a hello or anything like you get with SMTP servers.

    What logs would I expect to see the telnet request, to double check?

  3. #23
    Quadro Architect
    Join Date
    Jun 2006
    Location
    Around myself
    Posts
    2,075

    Default

    If you can telnet to 5060 - it means te port forwarding for TCP most probably works. But it gices you nothing, as you cannot make calls with TCP (can you make your ITSP call using TCP?).

    You need to make sure the UDP 5060 forwarding is done too. For that you can try to register a phone as a remote extension on <yourRouterIp:5060> so it will send a REGISTER message to Quadro. Then check in Quadro registration logs whether the message was received..

    Or another way - use some tool (for axample, "Essential NetTools", or XSpider) to generate UDP packets from outside to <your router's IP>:5060 and capture all packets on the Quadro (netcapture.cgi). If UDP forwarding on router works, you should be able to see your packets in the capture (view that using Wireshark/Ethereal).

  4. #24

    Default

    you can make calls, but you cannot recieve.

    im just throwing a stone in the bush here

    i had the same problem and it was actually a simple rule in the routing table the cased the problem

    where did you specify the incoming itsp call to go to?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Dial out while receiving a incoming call
    By andy.collins in forum General Discussions
    Replies: 5
    Last Post: 01-21-2014, 01:32 AM
  2. problem with the incoming call
    By newworld in forum Troubleshooting and Problems
    Replies: 1
    Last Post: 09-03-2007, 11:03 PM
  3. What’s BEST - route incoming call
    By megatron in forum Installation
    Replies: 2
    Last Post: 10-23-2006, 10:18 AM
  4. VOIP incoming call goes to ext 11
    By etolentino in forum 'How Do I' Questions
    Replies: 3
    Last Post: 08-21-2006, 09:56 PM
  5. Rem Etxs: Call in OK, but can’t receive
    By uspnetworks in forum Troubleshooting and Problems
    Replies: 4
    Last Post: 08-13-2006, 01:25 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •