Search:

Type: Posts; User: sotoole

Search: Search took 0.01 seconds.

  1. Replies
    5
    Views
    6,585

    Just purchased Snom MP, but have 4x...

    Just purchased Snom MP, but have 4x SASY-SOHO-0102-0100 which apparently does not support 5.2.x. Any chance of MP support being added for older Quadro's or am I stuck with using the 820 profile?
  2. Ashot, thank you very much for your reply, I was...

    Ashot, thank you very much for your reply, I was able to fix the issue with the information you provided. I was blinded by the upload form for "Custom Voice Messages" instead of the "Upload new...
  3. Quadro4x lost voice mails, greetings, and AA audio on USB drive

    Hello, I have a Quadro4x that has been working a couple years now. Recently, the system lost all voice mails, custom greetings, and Auto Attendant voice data. It looks like something happened to the...
  4. Replies
    4
    Views
    3,338

    Still stuck

    None of the above has worked. I tried setting up the route as KSComs suggested, however, I get a message "Access to this number blocked". Similar problem if I try removing the PBX filter as davrays...
  5. Replies
    4
    Views
    3,338

    Unconditional forwarding problem

    I have an extension that I have setup to unconditionally forward to the employees cell phone as they are no longer in the office and no longer need a desk phone. I've set unconditional forwarding to...
  6. Replies
    9
    Views
    5,104

    Thank you all for the feedback, very cool. I...

    Thank you all for the feedback, very cool.

    I have tried every combination I can think of the 7960 - both on hold, Ln1 active, Ln2 active, etc. with no success. Searching Google I have found...
  7. Replies
    9
    Views
    5,104

    Hi, I've had a 4x with Cisco 7960's for about...

    Hi,

    I've had a 4x with Cisco 7960's for about 2 years now. Has worked very well for my small office. My only complaint is that I can not join two existing calls into a conference. This scenario...
  8. Replies
    0
    Views
    2,925

    After upgrading to 4.07 I am now getting the...

    After upgrading to 4.07 I am now getting the message "Incompatible media parameters, can not establish call" on all outbound non-PSTN calls. Inbound calls are fine. I called my VoIP provider and we...
  9. Replies
    3
    Views
    5,483

    Depending on the phone your using you may also be...

    Depending on the phone your using you may also be able to do it in the phone. I use Cisco's dialplan.xml configuration to allow my users to dial without a PSTN access code, in which case the phone...
  10. Replies
    6
    Views
    7,827

    Mario, the Quadro's feature set is unbelievable,...

    Mario, the Quadro's feature set is unbelievable, but in my humble opinion the UI problem has nothing to do with the large feature set, or configurability. The primary thing that makes the system...
  11. Replies
    14
    Views
    19,091

    I've had very good luck with NexVortex. See...

    I've had very good luck with NexVortex. See www.nexvortex.com. Service has been reliable. I'm able to make any number of simultaneous outbound calls with the same account. I have multiple 800#'s each...
Results 1 to 11 of 11