Search:

Currently have two separate ISP's with both registered to my SIP provider. Authentication through IP address and both are registered to the provider. Appears that they are cycling to both all the...

Was this ever looked into?

Having quality issues on outbound, any idea's on how to try and pinpoint issue?

Epygi is 172.30.0.1, phone is .251 and .30 is gateway and 159.18.161.99 is Sip provider.


Local:...

we have 4 users on the system so not really busy.

Seeing the same thing on our 4x system.
Tue Jun 2 14:59:21 2009 STUN port detection Successful port(s): 6018;
Tue Jun 2 14:08:23 2009 STUN port detection Failed port(s): 6018; Successful...

You can download from http://sourceforge.net/project/downloading.php?group_id=146322&filename=siptapi_v_0.2.5.zip&a=58890465 and configure to utilize the dialer function. In addition the wiki is here...

Not sure if this is possible through the Epygi however a .net application that we are evaluating uses the above, is there a way to either use the hot call feature or configure the h323 in xp to call...

Have the following setup and wanting to setup the quadro 4x to route to either.

1. Static IP's on both ISP providers.
2. PEPLink www.peplink.com allow for 3 WAN balance inbound and outbound....

We have 2 providers 1 as primary and 2nd as backup in the event that the primary goes down. How do I configure this in call routing.

Looking at purchasing a linksys SRW224g4p, capable of multiple vlans and a juniper ssg-5 wireless router. Config would be adsl>SSG>SRW then using vlan's to separate the pc's (Wan side of 4x) and...

Disregard, have configured thru autoprovisioning.

Checking to see what Epygi recommends.

Have been trying to manually confg a 9133i to no avail. Could not find anything in the forum. Is there any documentation on this. Phone firm version 1.4.2.1081

Not using DHCP on Quadro4x, using openwrt and not having any luck with the dnsmasq.conf file at the moment.

Currently working on will advise.Thanks
Patrick

Currently working on configuring the DHCP as we are currently not using the Quadro4x as DHCP. Almost completed, then will advise the results. And yes it is with the Snom320 set.

Add


Edit


Delete


Select all

All keys are active lines, version is 6.5.8

Configured using autoprovisioning, still same problem, dropped call when line put on hold. Any other ideas?

left vm message from one ext to mine and system recorded past 1 min mark when usually it cuts off. So internally seems fine, just from external.

Will check on internal and advise.
Cheers

Yes call is dropping at exactly 1 min, however I have increased the time as originally set at 3, then changed to 5, then set back to 1 and then moved to 5 again to see if it would reset. When testing...

Any call, using call routing, codecs being used are G729a, IP-PSTNRouting Call Settings


Use Extension Settings:

00


Keep Original Caller ID:

Snom 320 is used, hold is being activated by the 320. Local extention, only 1 line key programed, transfers are being lost as well.
Cheers

When placing a call on hold, when retrieving caller, immediately after selecting line, call is dropped.