Search:

Hi,

Quadro is working with different type of FTP servers, as windows also linux based . As I see from logs your problem appears during ftp user authentication. So I can suggest to try with...

Hi,

it could be in case when tiff-to-pdf conversion is failed for some reasons. Then Quadro sends fax as tiff.

If problem will be persist just open TSS ticket by login with your...

Hi,
physically your Quadros are placed in same internetwork area or they are connected each other over internet ?

do not fill port, remove port and save the configuration, also read the http://www.voipvoip.com/linksys-pap2/
and change the listbox value as

Here is a link how configure Linksys NAT

http://www.voipvoip.com/linksys-pap2/

On Linksys web gui "SIP" page under "NAT Support Parameters" section you can find that params.

you can use epygi STUN server stun.epygi.com. Port: 3478.

Let`s try to change some configuration parameters on Linksys, especially on System page
https://www.mynetfone.com.au/media/support/downloads/linksys-pap2/config/config.html
check the DNS...

your Linksys device is sending to Quadro incorrect IP addresses in sip messages It`s a local IP address instead of global. Here is a part of incoming register message from your Lynksys pap2 device....

Hi,
are you sure that your device send that messages to Quadro ?
for checking that you can "mark all logs" make a call to gsm Gate and after that download the logs and send it to me or investigate...

Here is "System messages" files parameters:

1. Codec - PCMU (A/mu-Law Wave ".wav"), CCITT
2. Sample rate - 8000 Hz
3. Channels - Mono
4. Resolution - 8 or 16 bit

Programs which allow to...

Hi,
probably your mails are lost ,
when you configuring voice mail settings you can find "More notification optins >>>" on the bottom of that page, after clicking on that you get more...

Hi,
the message sizes (recorded/actualy played) difference depends on voice codec you are recording the voice messages, the messages size in minutes are calculated according to codec configured in...

Hi,
you are describe the problem or suggesting solution ? :)
what you mean:

"4xx is just an example for a way of being able to dial a trunk, you might need to change the entry to 601 to 610 or...

Yes , sure he can organize forwarding via AA also, but again he cant make filter for that call, I mean he can`t detect from where the call is arrived. That is why I suggest to use Filtering for...

For E1/T1 Gateway product line the extension doesn`t have any supplementary services, so the real variant is to use Filtering on call routing record.

Hi,
do you try to use the "Filter on Caller / Call Type / Modify Caller ID " checkbox for that call route. If you will use it, you can mention incoming caller for which that route should work, and...

agree !

Hi, in this case after reboot you should connect to your 4x via LAN port and first of all check if your board WAN interface has a valid IP address.

In general you can use the any SNMP applications starting from freeware
and up to commercial. On web there is epygi.mib file which you can
download then compile with your SNMP compiler and then...