Search:

Does Epygi offer a preferred firmware for the new Yealink S series phones. I'm trying to use a Yealink T48S on a Quadro 2X2 Firmware Version: 5.3.65

You can Web to the phone and make that change

Yes. I contacted Epygi support and they manually registered the phone as "other" instead of Snom 870.
Works fine now

Does any QX200 firmware support Aastra 6731i phones or 6757i phones
I am using Firmware 6.1.24 and it does not appear to support these phone types

Nevermind...I figured it out

trying to register a Snom 870 on a Quadro 2X2.
Will not register. IP has not been blocked by Quadro.
Any ideas?

Go ahead and set the Epygi up for 3 digit exts. Then simply delete the exts and rebuild them as 2 digit exts. Be sure to add 2 digit dialing to the routing table.

All inbound calls are programmed go to a ring group and then if unanswered, forward to "no answer" point of that ring group.
Some cell phones will not ring the phones that are in the ring group....

Also, music converted via the Epygi Media Streamer is always "fuzzy". Just never a clear, crisp sound

Is there a way to decrease the MOH volume. Many customers complain about it being too loud

Having trouble programming a RECORD key on Grandstream 2160. Can set all calls to be recorded, but want to be able to Manually record calls.
How do you program a RECORD key

I have a remote phone working off of a Quadro 2x2 (5.3.21 SW). I have a Yealink T22 working as a "remote" phone. This remote phone rings on all incoming calls but some of the calls do not show when...

Epygi Quadro 2X2 SW 5.3.14
Cannot redial calls from "Call History" list....Recording says "number dialed does not exist"

I have an Epygi Quadro 4L (Firmware 5.3.21) with 4 analog lines for dial tone. I am using 5 Snom 820 phones (Firmware 8.7.3.15).
Calls ring in to a virtual extension that has "many extensions...

I've programmed a Yealink T22 IP phone as a "remote" extension.
When making/receiving calls, the call connects but there is no audio.
The Quadro is behind a customer provided router. All phones on...

How do I build a Route/button to transfer a caller directly into a voicemail box without ringing the extension.

I have the SLAs programmed as you said. (haven't installed the system yet)
So, does that mean that every phone with the SLA appearance will ring on incoming calls?
Is there a way to ring only...

Thank you very much!

How do I set up Quadro 4L to emulate a key system... using SIP trunks?
I am using Snom 360 phones