PDA

View Full Version : Bypass Auto attendant



ediggin
04-07-2008, 05:09 PM
Hi

How do I bypass the auto attendant with the ISDN version of the Quadro 2xi, I read the following post but the FXO option says that there is no FXO ?

"By default all calls from PSTN are routed to Auto Attendant. You can change that from "Telephony -> FXO Settings" page and route all PSTN calls to the desired extension. lets say, ext. 11. Then to be able to ring all the phones together on incoming PSTn calls you need to enable Many Extension Ringing service on the ext.11. Click on ext. 11 on the "Users -> Extensions Management", then go to "Supplementary Services -> Caller ID Based Services" page, click on "Any Address", choose "Many Extension Ringing" and enable it. Then choose the phones that you want to ring on incoming calls and enable them too."

Thanks

Ed

KSComs
04-07-2008, 06:06 PM
It will be in the set up of the ISDN section of your line.... routing within the isdn wizard will be pointing to your 00 default aa

It should be under Telephony-->ISDN settings ( just under FXO )

Regards

Kevin

AramK
04-08-2008, 12:29 AM
The description cited above by you is for Quadros with FXO ports. "FXO Settings" page isn't available on the ISDN Quadros. You should go to "Telephony -> ISDN Settings" page, click on Trunk and choose the extension to which you want to route all the calls from ISDN, or you can choose the "Routing with inbound destination number" option.