PDA

View Full Version : M32X add a E1/T1 gateway



nmhelpdesk
12-18-2014, 05:09 PM
Looking for advice on how to add a E1/T1 gateway to my existing phone network, I want to basically replace the exisitng e1/t1 interface in the M32X with the new e1/t1 gateway device. I keep reading about a shared mode between two Quadro devices, but I can't really see where I can set this setting exists. Thanks!

KSComs
12-19-2014, 02:24 AM
ummmmm....

http://www.epygi.com/products/quadrom-dual-e1t1-gateway (http://www.epygi.com/products/quadrom-dual-e1t1-gateway)

o0

erwin1803
01-29-2015, 09:16 AM
good day, i have a quadro m32x but i dont know how to install and configure any help?thanks in advance

KSComs
01-29-2015, 03:31 PM
good day, i have a quadro m32x but i dont know how to install and configure any help?thanks in advance

Perhaps using the administration manual and installation guide that comes on CD could help you get started and familiar with the GUI.